MTTY - Flashing From INTERNAL STORAGE

http://forum.xda-developers.com/showpost.php?p=5337709&postcount=3

Follow this procedure for FLASHING YOUR ROM FROM INTERNAL STORAGE AFTER MTTY 

a: FULLY COMPLETE POST 1
b: Before you start grab: mtty1.42.zip

AND ENSURE YOU HAVE HARD-SPL ON YOU DEVICE!! 

Procedure:

1: Download a ROM of your Choice, RENAME the *.nbh for your ROM to: LEOIMG.nbh

2: Copy LEOIMG.nbh to the "Storage Card" of your Device.

3: Bring device into bootloader (Reset + Hold Vol Down), at first your HD2 will attempt to flash the LEOIMG.nbh you just copied to your Storage Card, you will have 2 Options, Press Vol Down to CANCEL THE UPDATE!! (DO NOT FLASH NOW!!) after pressing Vol Down you will now see the Red, Blue, Green screen showing "Serial" 

4: Connect device in bootloader mode to USB, the word "Serial" will change to "USB" 

5: Run mtty1.42.exe, You will se a box showing "COM1" from this list select "USB" - If USB isn't in the list, something has gone wrong in the "Driver Installation" Section of POST 1

6: Leave default parameters, (8 bits / Flow Control NONE / Stop bits 1 / Parity None / Local Echo No) and Click OK

7: Run following commands:


7a: Press enter first to get prompt (Will Show as EITHER USB> or CMD> - Personally Mine Showed CMD>)

---------------------
MTTY OUTPUT:
---------------------
CMD>
---------------------

7b: type "set 14 0" without the quotes to tell bootloader to boot the OS after reset:

---------------------
MTTY OUTPUT:
---------------------
CMD>set 14 0
HTCST ÚÈHTCEUSB>
---------------------

7c: type "task 29" to get your device formatted:

---------------------
MTTY OUTPUT:
---------------------
Cmd>task 29
Format BINFS start
Fill RSVD information for block 288 to 321
CE start sector=0x14, total sector of CE and TFAT=0x14
CE start start block=321, total block=1727
ERASE block 1337 FAIL !!!
Write 0xFF start page=0x5040, total page=0x1AFC0
Format BINFS end

Cmd>
---------------------

7d: type "task 8" to ask your device reboot:

---------------------
MTTY OUTPUT:
---------------------
Cmd>task 8

Cmd>
---------------------

8: Immediately DISCONNECT your device and hold "Vol Down" to Initiate ROM Flash

9: After ROM flash Hard-reset (Pen Reset, then Press and Hold Vol Up and Vol Down) again, on completion "Press Vol Up To Boot" Is displayed, press "Vol Up" and allow the ROM to boot.

---

Attached Files

mtty1.42.zip - [Click for QR Code] (17.8 KB, 335 views)